Features

• Cost less than regular installed fences
• Free standing, panels are simply clamped together
• Sets up easily in 30 minutes
• Completely portable and relocatable
• Sets on any level surface, no post holes to dig
• All galvanized construction to prevent corrosion

Phoenix “Flip-latch” offers a new concept in kennel latches… simply lift keeper and roll back for open position… to latch, flip keeper away from gate, allowing it to engage post and latch itself.

May be mounted left or right… for gates swinging in or out. Opens from both sides, easy for people, but almost impossible for dogs. Only 7/8″ clearance between posts.

Provision for a padlock.

No sharp edges to injure your dog… safe!

Hinge assembly

This hinge reduces clearance between frame and gate to approximately 3/8″. It is made for square welded gates. The gate itself (one side) becomes part of the hinge assembly, and takes the place of the regular frame hinge.

Standard size kennels, 4′ high

All panels have welded pipe frames and 11-gauge galvanized chain link mesh.

There is no horizontal centre rail on any panels.

There is vertical rail added to panels over 10′.

The standard kennels below are four feet high, have a 3-foot-wide gate complete with a latch and include all attachment hardware.

Standard size kennels, 5′ high

All panels have welded pipe frames and 11-gauge galvanized chain link mesh.

There is no horizontal centre rail on any panels.

There is horizontal centre rail added to panels with 9-gauge on all widths.

The standard kennels below are five feet high, have a 3-foot-wide gate complete with a latch and include all attachment hardware.

Standard size kennels, 6′ high

All panels have welded pipe frames and 11-gauge galvanized chain link mesh.

There is no horizontal centre rail on any panels 10′ and under.

There is horizontal centre rail added to panels with 9-gauge on all widths.

The standard kennels below are six feet high, have a 3-foot-wide gate complete with a latch and include all attachment hardware.